Franmar® Scorch-e-doo Scorch Remover

Scorch marks left by flash-cure units and dryers are an occasional fact of life for screen printers. Franmar® Scorch•e•doo™ Scorch Remover is the product to have on hand for the moment a white cotton shirt comes off the belt scorched and there are no extras in sight — it lifts light scorching so the garment can be saved instead of scrapped.

• Easy to use — spray, re-dry, done
• Money-saving recovery of scorched garments
• One gallon saves up to 240 shirts

How to use: Spray the affected area until damp. Run the garment through the dryer at reduced heat or a higher belt speed until dry; a warm iron or heat press may also be used. Repeat if necessary. Note: Scorch•e•doo will not work on medium to severe scorches or on polyester blends.

Typical uses: Rescuing lightly scorched white cotton garments after flash curing or dryer overheating.

Available size: Quart. (Franmar also offers a 12 Quart Case.)

Safety & Handling

• Handling: Use in a well-ventilated area. Wear gloves and eye protection — this product contains hydrogen peroxide and can bleach or irritate on contact. Avoid prolonged or repeated skin contact and wash thoroughly after handling. Keep out of reach of children.
• Storage: Store in the original, tightly sealed container in a cool, dry place, out of direct sunlight and away from heat and sources of ignition. Do not allow to freeze.
• Safety Data Sheet: A Safety Data Sheet (SDS) and Technical Data Sheet are available from Franmar at franmar.com/documents-sds. Consult the SDS before use.