Siser® Glow in the Dark Heat Transfer Vinyl – 12" / 15" / 20"

$15.99

Pickup at our Hackensack, NJ location. Ready 30 minutes after ordering (in-stock items). Hours: Mon–Fri 8:00 AM–4:30 PM, Sat 8:00 AM–1:00 PM. You may not get a “ready” notification — just come in after 30 minutes. Pre-coated screens and Pantone matches require 24 hours.

SKU: EW12P5081-1Yard
Width: 12"
Length: 1 Yard

Width

Length

Siser® EasyWeed® Glow in the Dark is a white polyurethane heat transfer vinyl that reads as a clean off-white in daylight and glows once the lights go out. Charge it under any light source for a few minutes and it holds a visible glow — brightest at first, fading gradually over the following hour or two.

It cuts and weeds like standard EasyWeed, so there is no new technique to learn. Available in 12", 15", and 20" widths.

Features

Charges under light, glows in the dark — no batteries, no coating, it's in the film.
Cuts and weeds like EasyWeed — same handling as the film you already run.
White in daylight — the design works in both states, not just at night.
Presses on leather as well as cotton, polyester, and blends.
Three widths — 12", 15", and 20".

Recommended Fabrics

100% Cotton
100% Polyester
Cotton / Polyester blends
Leather

Cutter Settings

Cricut — Blade: Standard · Setting: Iron-on

Silhouette Cameo — Blade: Standard, 2 · Material: Heat Transfer, Smooth · Speed: 8 · Force: 4

Brother ScanNCut — Blade: Standard, 2 · Cut Speed: 1 · Cut Pressure: 1

Roland GS/GX-24 — Blade: 45° · Gram-Force: 80–90 · Offset: .250 · Speed: 25–50 cm/s

Graphtec — Blade: 45° · Gram-Force: 8–9 · Tool: CB09+0 · Speed: 30 cm/s

Mimaki CG-60SR III — Blade: 45° · Gram-Force: 80 · Offset: 30 · Speed: 20–30 mm/s

Always cut mirrored, and test cut before running production.

Application Instructions

Mirror, cut, and weed the design.
Preheat the garment for 2–3 seconds.
Cover the design with a heat transfer cover sheet or multipurpose paper.
Press at 305°F / 150°C for 10–15 seconds using medium pressure.
Re-press for 5–10 seconds if any edge lifts.
Peel the carrier hot or cold.

With a home iron, set the dial between Cotton and Linen and press firmly 10–15 seconds per section without sliding. Test press on your specific garment first — platen temperature often differs from the display reading.