Franmar® Haze Remover Gel - DHaze Gel

D•HAZE® Gel Haze Remover clings to the affected area and gives screen printers far greater control when removing ghost and haze images. Because it is a gel it stays exactly where you put it and can be left on for long periods of time, letting it work on the worst staining without running off the mesh.

• Gel body clings to vertical mesh — targeted, controlled application
• Can dwell for long periods to break down heavy ghosting
• Removes tough haze and ghost images without damaging mesh
• Ideal for spot-treating problem areas rather than flooding a whole screen

How to use: Reclaim the screen and remove all ink and emulsion first. Apply D•HAZE Gel to the hazed area, set the screen aside and leave the gel to work. Scrub, then rinse the screen clean with pressurized water. Note: do not let D•HAZE Gel sit on the adhesive holding the mesh to the frame.

Typical uses: Spot-treating stubborn ghost images; dehazing screens where a liquid dehazer runs off before it can work.

Available sizes: Quart, Gallon and 5 Gallon.

Safety & Handling

• Handling: Use in a well-ventilated area. Wear chemical-resistant gloves and eye protection. Avoid prolonged or repeated skin contact and wash thoroughly after handling. Keep out of reach of children.
• Storage: Store in the original, tightly sealed container in a cool, dry place, out of direct sunlight and away from heat and sources of ignition. Do not allow to freeze.
• Safety Data Sheet: A Safety Data Sheet (SDS) and Technical Data Sheet are available from Franmar at franmar.com/documents-sds. Consult the SDS before use.

WARNING: This product can expose you to chemicals including n-methyl-2-pyrrolidone, which is known to the State of California to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.