Graphtec Compatible CB015U Cutting Blades

$20.00

Pickup at our Hackensack, NJ location. Ready 30 minutes after ordering (in-stock items). Hours: Mon–Fri 8:00 AM–4:30 PM, Sat 8:00 AM–1:00 PM. You may not get a “ready” notification — just come in after 30 minutes. Pre-coated screens and Pantone matches require 24 hours.

SKU: CB015U-30-2PK
Blade Angle: 30°
Pack: 2 Pack

Blade Angle

Tungsten carbide replacement blades for Graphtec plotters using CB015U blade holders.

CB015U or CB09U?

Check which holder your machine takes before ordering — they are not interchangeable. The CB015U is the larger-diameter blade used on many Graphtec FC and CE series plotters; the CB09U is the smaller standard blade. The part number is printed on your existing blade holder.

Which angle do I need?

Angle	Best for
30°	Thin and delicate materials — standard vinyl, thin HTV, fine detail. Longest blade life on thin stock.
45°	The all-rounder. Most vinyl, HTV, and cardstock. If you stock one angle, stock this.
60°	Thick and specialty materials — flock, glitter HTV, reflective film, sandblast stencil, high-density vinyl.

Don't run a 60° blade on thin vinyl. The steep angle cuts through the liner, lifts the material, and kills the tip early.

Specifications

Material: Premium tungsten carbide
Fits: Graphtec plotters using CB015U blade holders
Pack sizes: 2-pack and 5-pack
Note: Compatible replacement blades, not manufactured by Graphtec.

Getting the most from a blade

Set depth so the blade cuts the material and only scores the liner. Keep the holder clean — adhesive residue stops the blade swivelling freely, which reads as rounded corners on tight curves.

Angle

Best for

30°

Thin and delicate materials — standard vinyl, thin HTV, fine detail. Longest blade life on thin stock.

45°

The all-rounder. Most vinyl, HTV, and cardstock. If you stock one angle, stock this.

60°

Thick and specialty materials — flock, glitter HTV, reflective film, sandblast stencil, high-density vinyl.