Free shipping on orders over $250
Free shipping on orders over $250
Total Ink Solutions
Pickup at our Hackensack, NJ location. Ready 30 minutes after ordering (in-stock items). Hours: Mon–Fri 8:00 AM–4:30 PM, Sat 8:00 AM–1:00 PM. You may not get a “ready” notification — just come in after 30 minutes. Pre-coated screens and Pantone matches require 24 hours.
Tungsten carbide replacement blades for Graphtec plotters using CB09U blade holders. Same tolerances as OEM at a fraction of the cost — and since blades are a running consumable, that's where the savings actually land.
| Angle | Best for |
|---|---|
| 30° | Thin and delicate materials — standard vinyl, thin HTV, fine detail. Shallowest angle, longest blade life on thin stock. |
| 45° | The all-rounder. Most vinyl, HTV, and cardstock. If you stock one angle, stock this. |
| 60° | Thick and specialty materials — flock, glitter HTV, reflective film, sandblast stencil, high-density vinyl. |
Don't run a 60° blade on thin vinyl. The steep angle cuts through the liner, lifts the material, and wears the tip out early. Match the angle to the stock.
Set depth so the blade cuts the material and only scores the liner. Keep the holder clean — adhesive residue on the shaft stops the blade swivelling freely, which shows up as rounded corners on tight curves. If cut quality drops after cleaning and re-testing, the blade is done; replace it before blaming the material.
Related supply
